Low Boiler Pressure in Steyning

Many properties around neighbouring areas Road and the town centre are Victorian builds with original cast iron radiators. Regular bleeding releases trapped air but also water, gradually reducing system pressure over time.

The hard water in parts of the local area can cause pressure relief valves to weep or discharge externally. Check for water stains on outside walls near your boiler flue, particularly common in newer developments around newer housing developments.

Combination boilers popular in modern estates like Wynyard have internal expansion vessels that can lose their air charge over time. This causes pressure to fluctuate and drop, especially noticeable in winter when heating demand is highest.

Properties built in the 1980s-90s around local suburbs and the local area often have microbore heating systems. These small diameter pipes are more prone to developing pinhole leaks behind skirting boards or under floors, causing gradual pressure loss.

Take a photo of your pressure gauge and note whether it's reading low when the system is cold or hot. Pressure naturally increases slightly when heating is running, so check it when boiler has been off for a few hours.

Walk around your property looking for damp patches on walls, water stains on ceilings, or pooling near radiators. Check the area directly below your boiler and around the external discharge pipe for signs of water escape.

If your boiler has a filling loop (flexible braided hose with valves), you can attempt to repressurise the system. Only do this if you're confident - open both valves slowly until pressure reaches 1.2 bar, then close them.

Note if pressure drops happen after bleeding radiators, during cold weather, or gradually over weeks. This information helps identify whether it's a sudden leak, system issue, or normal maintenance requirement.